I love this rug! Design-wise, I was really winging it, but I couldn't have planned a better result. It actually looks three-dimensional, and the colors flow so nicely.
(Here's my previous post, which records most of the early steps in making it.) I purposely chose mostly medium colors, so it won't show the dirt as much as the larger one. These are entry rugs, so they trap the grit, wet, and general dirt coming into the condo.
In case you're wondering, washing one of these is not exactly easy, but it's not a terrible experience either. After a good shaking, I put it in the bathtub, add a little detergent and warm water, and then gently shove it around to get the dirt out. After several changes of water, when the water is clear and there's no more sand in the tub, I place it carefully into the washer, spin it, and pop it into the dryer. (I have a water-saving top-loader, so I can place the rug carefully around the sides to keep the strain minimal while spinning, and a very high percentage of the water is removed safely. Not sure how it would survive a front-loader.) I use cotton thread for joining the plaited strips, so I'm careful not to put too much strain on these rugs, especially when they're wet. I also overcast the two cut edges at least twice, and put two rows of wide multistitch zig-zags a little way in from the ends.
By the way, if you make one, make the plaited strips almost a foot longer than the desired rug length. After the plaited strips are sewn together, mark a cutting line on each end, do a straight stitch just to the inside of this line, then zig-zag over it before cutting. After cutting, do another zig-zag over the cut edge. If the cut line differs much from the marked line, add another straight stitch row and zig-zag row over the edge. I think that in every case, I've had to resew/recut the finished edges to make them more square. It takes some effort to keep the cut edges from expanding and ruffling. Add the two lines of multistitch zig-zag after you know you have finished edges. At first, the rug will not lie completely flat. It relaxes over the course of a few days.
Plaited rugs are not quick (they also eat a lot of thread). This one took roughly 35 hours (not including the ripping and resewing of the plaited strips, because the first time I couldn't be bothered to pin them), and it's only 28 inches by 57 inches. But they're beautiful, thin and flat, don't bunch up, light enough to wash and dry, and don't shrink or transfer dye to the floor. Definitely worth the effort.
3 comments:
its lovely. hard to believe those were once pants. congrats! how can you bring yourself to step on it?
I agree. I would never have the heart to step on them. In my home they would definitely go on the wall.
Have you tried hanging it on the wall?
I'm afraid hanging on the wall won't really work. When held by one edge, they distort. The plaiting can't be really tight, the way a traditional braided rug is tight. I think they're destined for the floor!
Post a Comment